////ZigBee S0 pulse counter with router
  • ZR-TDCI-EM

ZigBee S0 pulse counter with router

ZigBee S0 pulse counter with router

SKU: ZR-TDCI-EM. Categories: , .

Product Description

Key features

  • 2 pulse counter inputs S0 compatible
  • 2 thermal resistor inputs (NTC resistors not included)
  • Sampling and transmission rates are configurable
  • 12-24 Vdc/Vac supply
  • Routing function
  • External antenna
  • RF power amplifier: 10 mW

How it works

The ZR-TIDCI-EM is router ZigBee device, capable to count pulses emitted from flow rate meters (water, gas, electricity,…) and to measure the temperature from both the 2 on board NTC inputs. Pulse counters and temperature samples are sent at regular intervals to a Gateway of 4-noks products family.
Moreover, if temperature sensors are installed into an hydraulic circuit in the inlet and outlet pipes this device can send the difference between them.

Technical specs

General characteristics
Chip Ember EM250
Compatible IEEE 802.15.4
Stack EmberZnet 3.5.x (ZigBee PRO)
Modbus/RTU
Device address settable via internal dip-switch
Wall mounting with screws
Cable gland: PG9
Radio characteristics Frequency: 2405 MHz ÷ 2480 MHz
Modulation: DSSS
Nominal transmission power: 10mW (10 dBm)
Reception sensitivity: -97 dBm
External antenna gain: 5,5 dB
Coverage outdoor/indoor: 200m/50m
Power supply 12-24 Vdc/Vac; 100mA; 50/60Hz
NTC thermal resistor input NTC type resistor
103AT  type (R25 = 10 KOhm; Beta = 3435K)
Measurement range: -50°C ÷ +110°C
Measurement resolution: 0,1°C
Measurement accuracy : ±1,0°C
Measures are linearized at tenth of degree
Digital inputs Electronic type not insulated inputs for clean contact.
Short circuit current 0,01mA. Use self-cleaning  contact
Connection Pull out terminals (3,81 mm pitch)
Environmental conditions Operating temperature: -10 ÷ +60°C; <80% U.R. not condensing
Storage temperature: -20 ÷ +70°C; <80% U.R. not condensing
Degree of protection IP55
Conformity Community Directives 2006/95/CE, 89/336/EEC, 99/5/EEC; ETSI EN 300-328; ETSI EN 301-489; EN60950-1; EN50371; EN61000-6-2; EN 61000-6-3

Download