ZigBee module with 2 NTC inputs, 2 ditigal inputs and router
How it works
The ZR-TID-EM is an electrical energy supplied device which can measure at the same time the temperature of 2 NTC sensors and the status of 2 digital input and regularly send the collected information toward a 4-noks range Gateway. Is possible to set the device in order to manage alarms to ring when its limits are trespassed, because of a too high or too low temperature.
The device can transmit automatically and immediately (out of the sampling time you have set up) also for a status change of one of the two input.
Since the device is continuously supplied with a 12-24 Vcc/Vca it can work as a repeater and can work as “father” device for battery supplied sensors.
||Chip Ember EM250
Compatible IEEE 802.15.4
Stack EmberZnet 3.5.x (ZigBee PRO)
Modbus/RTU Address settable through internal dip-switch
Wall-mounting with screws
Cable gland: PG9
|Radio characteristics||Frequency: 2405 MHz ÷ 2480 MHz
Nominal transmission power: 10mW (10 dBm)
Receiver sensitive: -97 dBm
External antenna gain: 5,5 dB
Outdoor/indoor range: 200m/50m
|Power Supply||12-24 Vcc/Vca (±10%); 100mA; 50/60Hz|
|Inpur for NTC drill
||NTC type drill
103AT type (R25 = 10 KOhm; Beta = 3435K)
Measurement range: -50°C ÷ +100°C
Reading resolution: 0,1°C
Reading accuracy: ±1,0°C
Temperature measurements expressed as tenths of degree
||Non-isolated input for clean contact
Closure electric current 0,01mA.
Use self cleaning contacts
|Connection||Pull out terminals (3,81 mm pitch)|
||Operating temperature: -10 ÷ +60°C; <80% U.R. non condensing
Storage temperature: -20 ÷ +70°C; <80% U.R. non condensing
|Conformity||Community Directives 2006/95/EEC, 89/336/EEC, 99/5/EEC
Product law applied: ETSI EN 300 328: Radio Compatibility for digital wide band transmissions; ETSI EN 301 489: Radio Compatibility; EN 61000-6-2: Electromagnetic Compatibility – Emissions; EN 61000-6-3: Electromagnetic Compatibility – Immunity; EN 60950-1: Electric Security