ZigBee Optical Interface for energy meter

LED pulse counter of electricity and energy meter

SKU: ZR-TIDCI-OPT1-EM. Categories: , .

Product Description

Key features

  • LED pulse counter of electricity and energy meter settable from 1 to 99 Wh/pulse
  • It manages electricity and energy meter in Wh
  • Digital input for remote alarms
  • Compatible with ENEL energy meter (single phase/three phase); other European energy meters under development

How it works

The ZR-TIDCI-OPT1-EM counts, stores and transmits to a Gateway optical pulses generated by a counter ENEL, which correspond to a certain energy measured by the latter. The energy per pulse is set from 1 to 99 Wh. It is also supplied with a generic digital input that can be used to transfer a state of alarm coming from outside (with contact). The internal energy meter with resolution in Wh can be reset or set to a desired value to synchronize with the ENEL energy meter. The counts are transmitted on a regular basis and to a programmable Gateway. The device must be continuously powered to 12-24 Vdc / Vac (power supply included); it can also act as a repeater and or a parent device for battery-powered sensors.

Technical specs

General characteristics Chip Ember EM250
Compatible IEEE 802.15.4
Stack EmberZnet 3.5.x (ZigBee PRO)
Device address settable via internal dip-switch
Wall mounting with screws
Cable gland: PG9
RF characteristics Frequency: 2405 MHz ÷ 2480 MHz
Modulation: DSSS
Nominal transmission power: 10mW (10 dBm)
Receiver sensitivity: -97 dBm
External antenna gain: 5,5 dB
Range outdoor/indoor: 200m/50m
Supply 12-24 Vdc/Vac; 100mA; 50/60Hz
Power supply included 230 Vac (±20%); 50/60Hz
Digital input Electronic type not insulated inputs for clean contact.
Short circuit current 0,01mA. Use self-cleaning contacts.
Connections Pull out terminals (3,81 mm pitch)
Environment parameters Operating temperature: -10 ÷ +60°C; <80% U.R. not condensing
Storage temperature: -20 ÷ +70°C; <80% U.R. not condensing
Degree of protection: IP 55
Compliant 2006/95/EEC, 89/336/EEC, 99/5/EEC directives
Reference Norms: ETSI EN 300 328: Radio Compatibility for digitals wide band transmissions; ETSI EN 301 489: Radio Compatibility; EN 61000-6-2: Electromagnetic Compatibility – Emissions; EN 61000-6-3: Electromagnetic Compatibility – Immunity; EN 60950-1: Electric Safety