ZigBee hall effect sensor for direct current measurements
ZED-ICC-M

Key features

Hall effect sensor for direct current measurements
Range between 0 and 1000A
Simple and quick installation, without services interruptions
Alarm thresholds
Sampling and transmission rates are confi gurable
Battery powered
Internal antenna

The ZED-ICC-M is a battery powered ZigBee device that can perform direct current measurements through the Hall effect sensor and send them at regular intervals to one of a Gateway of the 4-noks products family.
This measure is based on the magnetic effect caused by the electric current fl ow along the conductor. To properly use this sensor, it should be placed on the conductor at a distance that is proportional to the amount of current that is to be measured. The range is between 0 and 1000 Acc.
This device may be confi gured to manage alarm thresholds for exceeding maximum or minimum current levels. It is also possible to adjust the sampling and data transmission rate to improve battery life.

Technical Specs
General characteristics	Chip Ember EM250 Compatible IEEE 802.15.4 Stack EmberZnet 3.5.x (ZigBee PRO) Modbus/RTU Device address settable via internal dip-switch Mounting on conductor which current is to be measured
RF characteristics	Frequency: 2405 MHz € 2480 MHz Modulation: DSSS Nominal transmission power: 2mW (3 dBm) Reception sensitivity: -95 dBm Internal antenna gain: 0 dB Coverage outdoor/indoor: 100m/30m
Supply	AA high energy density lithium battery 3,6V/2000mAh Battery life: 3 years in case of 1 transmission per minute at 20‹C
Direct current sensor	Hall effect CSA-1V type sensor non-linearity error <1% Sensitivity 280 V/T Linear measurement range -5 mT € +5 mT Response time < 6ƒÊs Measures represented in tenths of Ampere
Environment parameters	Operating temperature: -10 € +60‹C; <80% U.R. not condensing Storage temperature: -20 € +70‹C; <80% U.R. not condensing Degree of protection: IP 55
Compliant with 2006/95/EEC, 89/336/EEC, 99/5/EEC directives Reference Norms	ETSI EN 300 328: Radio Compatibility for digitals wide band transmissions ETSI EN 301 489: Radio Compatibility EN 61000-6-2: Electromagnetic Compatibility-Emissions EN 61000-6-3: Electromagnetic Compatibility-Immunity EN 60950-1: Electric Safety